Which Sidestand

Message

Aladinsaneuk · #16 Post by **Aladinsaneuk** » Fri May 23, 2008 8:59 pm

due to the raised height of the back end, after fitting a wp rear shock, I am in the process of fitting the original sidestand

BUT - I am going to use the VTR switch as it is a lot better than the standard falco one - a metal pin as opposed to a plastic bump....

IF that does not work out as I want then I guess I will start to look at fitting an allen bolt But i thght i would try the original first

sabestian · #17 Post by **sabestian** » Sat May 24, 2008 8:48 pm

Aladinsaneuk wrote: IF that does not work out as I want then I guess I will start to look at fitting an allen bolt

Start looking :)

Aladinsaneuk · #18 Post by **Aladinsaneuk** » Sat May 24, 2008 9:07 pm

actually, is fine.....

I am, by nature, a fat bastard, so the shock is fairly meaty, and the rear end is quite a bit higher now :)

am quite pleased - only thing I did was to drill a hole for the VTR switch as it is far better than the aprilia one....