abm fatbar yokes and risers

Message

roosterNI · #1 Post by **roosterNI** » Tue Mar 08, 2011 9:53 pm

anyone interested in a set of abm yokes and fatbar risers? same as on the streetfighterstore.com these fit falco 53mm forks. they also come with extra 35mm risers because i found when fitting the yokes that i couldn't run the forks 5 lines above the yokes without touching the bars, if you look at the tuono risers you'll see what i mean there very long. was looking £80 plus p+p. there 160 on streetfighterstore plus the extra risers.

also have a set of early mille rearsets, looking 25 plus p+p.

Nooj · #2 Post by **Nooj** » Tue Mar 08, 2011 10:11 pm

D'oh! Just finished a Renthal conversion and now these come up as well as the ones BenWah was selling recently.

Falcoholic · #3 Post by **Falcoholic** » Wed Mar 09, 2011 9:59 am

PM sent re rear sets

Falco9 · #4 Post by **Falco9** » Wed Mar 09, 2011 1:26 pm

Nooj wrote:D'oh! Just finished a Renthal conversion and now these come up as well as the ones BenWah was selling recently.

Me too!

A complete PITA! My timing always was rubbish.....this just proves it

F9

roosterNI · #5 Post by **roosterNI** » Wed Mar 09, 2011 3:11 pm

sorry chaps! i'm only selling them cause i got a set of tuono yokes instead. pm replied

roosterNI · #6 Post by **roosterNI** » Wed Mar 09, 2011 7:49 pm

pics of the rsv rearsets and the yokes.[/img]

Willopotomas · #7 Post by **Willopotomas** » Wed Mar 09, 2011 7:52 pm

Blimey.. Are those risers a bought item or something you've made up?

Nooj · #8 Post by **Nooj** » Wed Mar 09, 2011 7:57 pm

Look like the Oberon ones are they? Bit odd that ABM didn't realise that the bars would interfere with the fork tops in standard trim. Fail!

roosterNI · #9 Post by **roosterNI** » Wed Mar 09, 2011 8:03 pm

its not that they interfere but the forks would have to be flush with the yoke, therefore raising the front of the bike. there bought items, check the lenght of the tuono ones, do the same job they just look better!

BenWah · #10 Post by **BenWah** » Wed Mar 09, 2011 9:52 pm

That's not quite right. The ABM yokes are flat, whereas the Falco yokes drop towards the fork. This means they look flush when they are in fact the same as having three rings showing. So if you've got one ring showing on the ABM's it's the same as dropping one ring on the standard yokes.

There's room to drop two rings over standard on the ABM yokes. Things start getting twitchy at that point, especially if you've raised the rear too.

B

roosterNI · #11 Post by **roosterNI** » Thu Mar 10, 2011 2:37 pm

never realized that, thanks for telling me! it shakes the head the odd time. could bring it up a few rings then.

roosterNI · #12 Post by **roosterNI** » Fri Mar 25, 2011 2:10 pm

yokes and risers sold