clutch pin/rod and barrel

Message

scottyni · #1 Post by **scottyni** » Mon Jun 15, 2009 7:16 pm

looking for the plunge rod and barrel if any spare ??????

not paying for a full lever (£80) when all i need is that little part.

tried a few places and no joy, only option is too make my own (pin/rod) one.

Falco9 · #2 Post by **Falco9** » Mon Jun 15, 2009 9:18 pm

Mark,
Keep looking on fleabay. A number of levers come up on there all the time. Worth bearing in mind that this is the same lever used on loads of Ducatis as well, so worth scanning for them as well.
Get the seller to send a photo to make sure your bidding on ther right one though

F9

shootmyscoot · #3 Post by **shootmyscoot** » Tue Jun 16, 2009 9:58 am

hi
i did post a solution on the aprilia forum for you when mine broke,
i drilled the retsainer and used a large pop rivit

sms

scottyni · #4 Post by **scottyni** » Wed Jun 17, 2009 6:28 am

sms

how good a fit into the barrel was the rivet and the pin part was strong enough for the job

got a pin barrel and lever part coming from oz, just hope i can free it and use it in my black levers i bought.

if not then i'll go down the rivet way

shootmyscoot · #5 Post by **shootmyscoot** » Wed Jun 17, 2009 10:13 am

it fitted perfectly, i just left some lenth on the rivit and folded the wing back slightly, i wouldnt recommend it for long term use,
however i still using it 2yrs on, as i couldnt find 1 any where.

sms