dyno figures

Message

paddyz1 · #1 Post by **paddyz1** » Fri Jun 08, 2007 5:12 pm

Had the bike dyno-ed today. I posted it up on the AF1 site.

Any comments welcome

http://www.apriliaforum.com/forums/show ... p?t=118262

Samray · #2 Post by **Samray** » Fri Jun 08, 2007 5:22 pm

Smoothed that impressively.

D-Rider · #3 Post by **D-Rider** » Fri Jun 08, 2007 6:49 pm

That's a good piece of DIY Paddy !

#4 Post by **Kwackerz** » Fri Jun 08, 2007 6:59 pm

Gio · #5 Post by **Gio** » Fri Jun 08, 2007 7:26 pm

Not bad at all, looks better from 7 grand upwards tho.

Has your bike been re-jetted, something say no to me, but then I'm normally wrong

#6 Post by **Kwackerz** » Fri Jun 08, 2007 7:35 pm

rejetted?

D-Rider · #7 Post by **D-Rider** » Fri Jun 08, 2007 7:36 pm

Gio wrote:Not bad at all, looks better from 7 grand upwards tho.

Has your bike been re-jetted, something say no to me, but then I'm normally wrong

Don't think he's ditched the fuel injection for a carb set-up Gio !

#8 Post by **Kwackerz** » Fri Jun 08, 2007 7:40 pm

I think he meant uprate the injectors and adjust the stacks...

Gio · #9 Post by **Gio** » Fri Jun 08, 2007 7:51 pm

Kwackerz wrote:I think he meant uprate the injectors and adjust the stacks...

You fecking know what I mean

paddyz1 · #10 Post by **paddyz1** » Sat Jun 09, 2007 8:03 am

Thanks guys. The only thing changed are the velocity stacks to the short aluminium type. I haven't put the 54mm throttlebodies on yet because I havent got the money for a PC111 which it will need.

Here is the Vid I done while I was there. Listen for the induction

http://www.youtube.com/watch?v=cW6JDQ3Engc