Page 1 of 1
Banjo Bolt with Bleed Nipple...
Posted: Sat Aug 29, 2009 2:15 pm
by GregD-UK
Hi all,
Want to put a banjo bolt with a bleed nipple on my top connection on the clutch hose. Is it a 10mm x 1.00mm or 10.00mm x 1.25mm? Have no clue, any help much appreciated
Re: Banjo Bolt with Bleed Nipple...
Posted: Sat Aug 29, 2009 9:12 pm
by D-Rider
GregD-UK wrote:Hi all,
Want to put a banjo bolt with a bleed nipple on my top connection on the clutch hose. Is it a 10mm x 1.00mm or 10.00mm x 1.25mm? Have no clue, any help much appreciated
Well, coincidence of coincidences .... a little while ago I bought one of these from RSVR.net (when it was still trading .....).
I got it out today to fit to the bike - but ran out of time (have to do it tomorrow).
That's just as well as I've still got it to hand.
Unfortunately I haven't got a thread gauge but I've taken a pic next to a rule.
Banjo Bolt with Bleed Nipple...
Posted: Sat Aug 29, 2009 10:30 pm
by GregD-UK
Hi all,
Cheers DR, looks like 10mm x 1.25mm to me
What a spot of luck fella...
Posted: Sun Aug 30, 2009 12:32 pm
by D-Rider
Wasn't convinced it was a 1.25 thread .... so I popped on my reading glasses to have a look and also took a better pic.
Looks like a 1mm thread to me.
Banjo Bolt with Bleed Nipple...
Posted: Sun Aug 30, 2009 3:08 pm
by GregD-UK
Hi all,
Oh Sugar! Ordered a 10mm x 1.25mm last night on fleebay
See if I can change the order....
Thanks again DR.
Posted: Sun Aug 30, 2009 8:43 pm
by mangocrazy
Brembo stuff is almost always M10 x 1.0 thread pitch. As you're threading into a Brembo clutch master cylinder I'd be pretty sure it will be M10 x 1.0.
Incidentally, bleedable banjo bolts are available in stainless from this eBay seller:
http://cgi.ebay.co.uk/GOODRIDGE-BANJO-B ... 286.c0.m14
Banjo Bolt with Bleed Nipple...
Posted: Sun Aug 30, 2009 9:16 pm
by GregD-UK
Hi all,
Cheers mangocrazy, will have a look
