Anyone know where I can buy (borrow even better), a Peg Spanner.
Reason, I have now, over a period of many many months and a fair bit-o-dosh, got all the bits I need to swap bits n bobs on my falco.
I have a 2007 Mille-R swinger and Ohlins shock to install, I was going to do it today, I thought that I would first double check I had all the tools etc I required, (good job I did), then found that I didn't have the said spanner. So job now on hold.
Tried looking on t'interweb but found nowt to do wi Peg Spanners.
Got 2 shops I can pop into tomorrow to ask, but not going to hold my breath.
As I'v said in the past, I'v never done any mechanical stuff like this before, and want to get it right first time. Did think of using a screwdriver/hammer to loosen the nut, but then I would not be able to tighten it to its correct torque setting afterwards..... ho hum....
It never crossed my mind to think of bicycle shops.... amazing.... I owe you each a beer or three. 
as I could not find a 2nd hand one on flea-bay for love nor money, so bit the bullet and got one with ride height adjustable and remote preload. The canister is horizontal, so should not have any space problems (I hope).
Will check it out. Thanks. I bought the whole shebang complete from Time Machine Bikes who were very good. But must admit not heard anything about plates splitting!!! Only the first model swingarms cracking.
