CNC operator needed

Message

Nooj · #1 Post by **Nooj** » Wed Jan 05, 2011 12:08 am

Any machiniststs in here? I need a couple of small ally parts milling ( I can provide the ally), also got a small amount of hard anodizing (in black) I need doing. ASAP please.

Willopotomas · #2 Post by **Willopotomas** » Wed Jan 05, 2011 6:35 pm

Depends what needs doing. Got manual machines at my place (plus the waterjet) and know how to use them..lol.. Drop me a PM or e-mail.

joecrx · #3 Post by **joecrx** » Wed Jan 05, 2011 6:48 pm

what you up to nooj ? is your hacksaw getting blunt

are you needing things made to less than 10mm tolerence

Nooj · #4 Post by **Nooj** » Wed Jan 05, 2011 6:48 pm

Groovy, baby! Will get some drawings together by early next week. It's nothing big or difficult, just a couple of wedged rectangular spacers with a 10mm hole though the middle of each. I could do it with hand tools, but it would look so much better machined.

Nooj · #5 Post by **Nooj** » Fri Jan 07, 2011 7:23 pm

Will, I've done a very poor drawing, will send it out to you.

Willopotomas · #6 Post by **Willopotomas** » Fri Jan 07, 2011 11:06 pm

Reply sent dude.. Not had the drawing yet.

Nooj · #7 Post by **Nooj** » Sun Jan 09, 2011 11:18 pm

Have sent you Yorkshire post (Eeeeeee, mail).