RiderSite.com - Motorcycle Forums

Posted: **Sat Aug 24, 2013 7:14 am**

Morning all,

well last week i swapped my vfr400r nc30 for a big bruiser ie zrx1100 and i love it, so now to the questions.

Does anybody kn now which 4pot nissins fit straight in?i know some do but not sure which ones.

anybody got a cheap road legal can for one?

Thanks

Posted: **Sat Aug 24, 2013 8:50 am**

The suzuki Gsxr k1 calipers may fit, you'll need to check. I know htey fit a few kwaks, I used to have them on a project but I had to turn up some adaptor bushes (You can get shouldered screws instead)

Posted: **Sat Aug 24, 2013 8:59 am**

Hello mate.

I used to have a ZRX 1200R. Awesome machine.
Anyhoos,there's a really good forum (www.zrxoc.com)
Some of the guru's on there know as much about zrx's as the guru's on here know about falco's.

Del

Posted: **Sat Aug 24, 2013 5:01 pm**

cheers slick....wayno ideally want four pot calipers as four big piston much better than six smaller ones IMHO

Posted: **Sat Aug 24, 2013 5:49 pm**

robbier6 wrote:cheers slick....wayno ideally want four pot calipers as four big piston much better than six smaller ones IMHO

Helluva lot easier to work on as well !

Posted: **Fri Oct 04, 2013 7:45 am**

Indeed they will be, and cheaper for pads too.

Joined the ZRX forum, seem a good bunch though i'm not allowed in the bar until i get to 20, (posts that is) long time since that was my age.

Seems you can do as much to the ZRX as you can to the falco.

Posted: **Fri Oct 04, 2013 11:12 am**

Hi mate, the K1 calipers are 4 pots. The 6 pots are the same fitment I believe but like you I prefer the 4 pots

Posted: **Fri Oct 04, 2013 1:41 pm**

Thanks Wayno, i never realised they were 4pots..fit straight in ya say?

having been on the zrxoc, it appears that rf900 calipers are a straight swap no less, plus being an unpopular machine may pick a set up cheap

Posted: **Fri Oct 04, 2013 7:31 pm**

I can't guarantee they will be a straight fit, but if fitted some to a zxr400, a mate has fitted some to a zzr1100 and I heard they will fit the zrx, you'll have to check the hole pitch, and you will definitely need some top hat spacers or shoulder bolts. And the the tokico's look loads better

Posted: **Fri Oct 04, 2013 8:36 pm**

I can't guarantee they will be a straight fit, but if fitted some to a zxr400, a mate has fitted some to a zzr1100 and I heard they will fit the zrx, you'll have to check the hole pitch, and you will definitely need some top hat spacers or shoulder bolts. And the the tokico's look loads better

Posted: **Sun Oct 06, 2013 8:25 pm**

I'll have a word with my mechanic mate ask him to let me know when a k1 comes in for a service...then I'll pop over with my verniers