Page 1 of 1
Sprag clutch bolt size
Posted: Wed Aug 10, 2011 9:03 pm
by szrdave
Following my other thread I've got a new (2nd hand) stator on its way to replace the mangled one.
I just need to know the size of the bolts that hold the sprag to the back of the rotor? As mine got thrown away along with the bits of torn stator winding and chips from the inside of the flywheel!
a technical answer
Posted: Wed Aug 10, 2011 9:27 pm
by flatlander
small enoiugh to fit
big enough not to fall out
sorry
IGMC
Re: a technical answer
Posted: Wed Aug 10, 2011 9:40 pm
by szrdave
flatlander wrote:small enoiugh to fit
big enough not to fall out
And strong enough not to shear off
Re: Sprag clutch bolt size
Posted: Thu Aug 11, 2011 6:28 am
by mcbones
szrdave wrote:Following my other thread I've got a new (2nd hand) stator on its way to replace the mangled one.
I just need to know the size of the bolts that hold the sprag to the back of the rotor? As mine got thrown away along with the bits of torn stator winding and chips from the inside of the flywheel!
M8 x16
Posted: Fri Aug 12, 2011 11:11 am
by szrdave
Thanks!!
Replacement stator has arrived so hoping to have it back together this weekend, weather dependant.