Page 1 of 1
Tyre valves...
Posted: Tue May 17, 2011 6:39 pm
by rick
...need a new bolt for the rear one (noticed a crack in it) so thought I may as well replace the front and rear when I change tyres in a couple of weeks.
So quick question... will these fit? 8mm?
http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... 2717wt_700
Sorry... being lazy and cant be arsed to go out to garage!
Posted: Tue May 17, 2011 6:59 pm
by Nooj
Don't know if they fit, but I'd look for something in stainless steel rather than these, you really don't want corroding valves!
Posted: Tue May 17, 2011 7:19 pm
by rick
ok good point!
Posted: Tue May 17, 2011 11:00 pm
by Falcopops
They should be ok, but I got a set of angled ones
HERE
Since it's a pain in the proverbial trying to use garage air lines and you're making the change anyway I'd suggest you consider angled ones.
Posted: Wed May 18, 2011 6:04 am
by Aladinsaneuk
iirc italian bikes have a different size apeture to the rice burners - ask at a reputable tyre fitters and they will tell you
Posted: Wed May 18, 2011 7:56 am
by D-Rider
From dale's ebay link:
Posted: Wed May 18, 2011 8:03 am
by Falcopops
The seller also queried my choice and was happy that I'd ordered the right ones for an Aprillia.
Not tried fitting them yet though.
Posted: Wed May 18, 2011 10:03 am
by roosterNI
angled ones really are the job, my tyre fitter had them in stock no problems.
Posted: Wed May 18, 2011 10:31 am
by Samray
D-Rider wrote:From dale's ebay link:
He can't go thro all that squit on a superdooper mobby phone connection.
