Page 1 of 1
possibly looking for some sheet metal work....
Posted: Mon Dec 13, 2010 2:53 pm
by Aladinsaneuk
as my exhausts like to munch on huggers - and yes CF will melt when kept close to a renegade system - I started thinking about getting a hugger made in metal..... obviously would not have to be sepecially strong as its main job would be to just keep crap off the undertray, but any one any ideas on a company that could do such work?
Posted: Mon Dec 13, 2010 7:05 pm
by Willopotomas
Yes, but you're talking mega bucks for that sort of work.
PM sent.
Re: possibly looking for some sheet metal work....
Posted: Mon Dec 13, 2010 8:16 pm
by D-Rider
Aladinsaneuk wrote:possibly looking for some sheet metal work....
.... and for only a little extra you could probably get some decent metalwork .....
Posted: Mon Dec 13, 2010 9:02 pm
by Samray
Posted: Tue Dec 14, 2010 6:20 pm
by MartDude
Pete - a fabricator friend suggests having a look at a hugger/mudguard for a Harley, and seeing if it could be modded - much cheaper.
Posted: Tue Dec 14, 2010 8:35 pm
by D-Rider
Posted: Tue Dec 14, 2010 11:58 pm
by Falcopops
The hugger on the old RSV arm isn't all that complicated is it?
IIRC it's all straight lines, or does it have a curve on it, I'll need to check.
Posted: Wed Dec 15, 2010 12:02 am
by Aladinsaneuk
straight lines on the base, but curved angle over it
