RiderSite.com - Motorcycle Forums

I have sourced a bar and I'm going about moving the bars above the top yoke.

Can anyone tell me the thread on the master cylinder for a double banjo bolt? I need one to replace the hoses.

Thanks.

Pretty sure it's M10 x 1.0 (that's the Brembo standard), Japanese bikes tend to be M10 x 1.25.

I thought it was, just wanted confirmation.

Bars are moved. Clutch hose is a little tight at full lock. I'll look at that tomorrow. I also had to make some lock stops to stop the bars fouling the tank. I have an even worse turning circle now

Good stuff! Now we need proof in the form of pictures...