Following my other thread I've got a new (2nd hand) stator on its way to replace the mangled one.
I just need to know the size of the bolts that hold the sprag to the back of the rotor? As mine got thrown away along with the bits of torn stator winding and chips from the inside of the flywheel!
Sprag clutch bolt size
Moderators: Aladinsaneuk, MartDude, D-Rider, Moderators
Sprag clutch bolt size
'96 SZR660
'00 Falco
1.5 Italian bikes!
'00 Falco
1.5 Italian bikes!
-
flatlander
- Eprom Test Pilot (Stig)
- Posts: 3097
- Joined: Tue Jun 14, 2011 9:06 pm
- Location: cheshire
a technical answer
small enoiugh to fit
big enough not to fall out
sorry
IGMC
big enough not to fall out
sorry
IGMCFor the avoidance of doubt and for the benefit of my wife, not everything I may say here will be absolutely true I may on ocassion embellish a little for effect.
That said when it comes to motorbikes, I like to ride side saddle with a nice frock
That said when it comes to motorbikes, I like to ride side saddle with a nice frock
Re: a technical answer
And strong enough not to shear offflatlander wrote:small enoiugh to fit
big enough not to fall out
'96 SZR660
'00 Falco
1.5 Italian bikes!
'00 Falco
1.5 Italian bikes!
Re: Sprag clutch bolt size
M8 x16szrdave wrote:Following my other thread I've got a new (2nd hand) stator on its way to replace the mangled one.
I just need to know the size of the bolts that hold the sprag to the back of the rotor? As mine got thrown away along with the bits of torn stator winding and chips from the inside of the flywheel!